COP - Relief pad for duty belt MOLLE adapter hook-and-loop

The Cop relief pad for duty belt MOLLE adapter hook-and-loop ensures that the belt adapts even better to the wearer’s anatomy. The diameter at the lower end of the belt is larger and the pressure on the hip bones is significantly reduced. The padded relief / inner belt has no buckle. It is equipped with MOLLE loops on the outside and hook-and-loop on the inside plus additional mesh fabric. This allows you to fix it to an underbelt with loop-side hook-and-loop. The advantage is that you can continue to use your existing duty belt, as it is threaded behind the MOLLE loops (the tunnel is suitable for belts up to 60 mm wide). Belt keepers are attached to both belt ends to provide additional security for the duty belt. When removing the system, the relief pad / MOLLE adapter normally remains on the duty belt.
The connection to the underbelt is made via a loop-side hook-and-loop underbelt. You should choose the size of the inner belt so that it does not overlap under the buckle of the outer belt, but always leaves a gap.
If the duty belt is routed in front of the MOLLE loops at some points, you can thread holsters onto the duty belt. This gives you a combination of MOLLE loops and duty belt.

Sizes:
- M/L = six sections with three loops and three MOLLE rows each, minimum hip circumference 90 cm.
- XL/XXL = eight sections with three loops and three MOLLE rows each, minimum hip circumference 112 cm